Dot and Dab
With P B Drylining you are assured of a top notch service to meet your
requirements. Dot and dab is the process where the drylining is glued to the blockwork using plaster dabs. In situations where insulation levels require increasing, composite boards can be used for dot and dab. The dabs of plaster are applied to the back of the boards and the boards are then fitted against the wall and tapped into position with a long straight edge. The dot and dab procedure requires a great deal of experience. You will need a good plastering and drylining company, such as P B Drylining, to perform the dot and dab for you.
If you require a plastering company to perform the service for you then we can offer the perfect plastering solution.
Direct Bonding may be specified with confidence for application to most masonry backgrounds depending on the condition:
When minimum cost and simplicity of application is required
Where the background is plumb, dry and sound
For a stand off of 10-25mm.
This dot and dab system utilises one layer of plasterboard or insulating laminate boards. These boards are fixed with bonding compound in a regular pattern known as dot & dab, allowing the boards to be fixed with minimum projection. The system allows overriding nominal irregularities in the background and will accommodate shallow service runs within the lining void.
Our plastering background is unparalleled in the UK and we offer value services for businesses and organisations looking for a high standard of plastering application.
If you have any questions about our dot and dab service then please feel free
to contact us today and we will do all we can to answer the queries that you
have. We always enjoy hearing from our clients and will help you in any way that
we can to help answer those questions you have for us here at PB Drylining.